Powerenz LiPo 48 - 50W

Product Details:
In Stock
Product Code: LiPo48-50W


$825.00
$875.00

X







 Powerenz LiPo 48 - 50W

     In the photo below, one can see the hard case opened and laying on the ground, the 50-watt solar panel unfolded, and the cover of the control panel opened exposing all of the power-in plug-ins and power-out ports.  The foldable 50-watt solar panel consists of 5 separate and linked 10-watt high-efficiency monocrystalline solar panels.

      This water-resistant system will deliver a maximum of 96 watts/8 amps of power via one 12-volt cigarette lighter socket, 350 watts of continuous 120-volt/60 Hz power until the battery runs out of energy, and is best suited to provide power for small and medium size portable electronics, including laptops, communication radios, battery chargers, media players, iPhones/Pads, Tablets, small power tools, energy-efficient lights, small energy-efficient refrigeration/freezer units, CPAP machines, etc.  If the power draw of your electronic device is 60 watts, the battery will last approximately 8 hours in the absence of incoming solar power before it needs to be recharged, longer if the power draw is less.  The preferred maximum current draw from the cigarette lighter socket is 5-8 amps (96 watts max) to prevent excessive generation of heat, though it will deliver up to 13 amps for short lengths of time.  If the current draw from the cigarette lighter socket exceeds 13 amps, power delivery will automatically shut down, then re-set itself once the load has been disconnected.  If the power draw on the inverter exceeds 350 watts, the overload protection function will automatically shut off power until the load has been disconnected.  The cigarette lighter socket and the AC outlet may be used simultaneously.  The battery pack, solar charge controller, inverter, control panel, LED light and switch, operational LCD display screen, master power ON-OFF switch, and solar array are built into and enclosed in a water-resistant (IP65) and dust-proof hard case.  

     Powerenz LiPo 48 - 50W comes with: Battery: 48 amp-hour (532.8 watt-hour) lithium polymer unit that is rated to provide 1000 discharge-charge cycles.  The conditions of your operation will most likely vary from standard operation conditions, so the number of expected cycles will also vary.  The battery pack comes configured with a protective circuitry module that limits the discharge current to 32 amps/355.2 watts.  To maintain the battery pack, please recharge it every 3-4 months until it is completely charged, and do not allow the digital state-of-charge indicator to drop to 0%.  Solar Charge Controller: 8-amp unit that uses PWM technology.  Solar panel: five CE, ROHS, and PSE-certified, monocrystalline 10-watt/18-volt (total 50W/2.78 amps) units linked together and arranged in a fold-up and fold-out configuration that will require approximately 18 hours of peak sunlight to completely recharge the battery if it is depleted, and that is built into the hard caseAC-powered battery charger: built into the hard case is a 6-amp "smart" worldwide unit that operates via North American 120 volts AC, that plugs into a standard North American AC receptacle via an included connector-extension cable that plugs directly into the control panel, and that will require approximately 9 hours to recharge the battery from empty to full.  Inverter: continuous 350-watt pure sine wave unit.  Control panel: encloses one 3-prong AC outlet (350 watts), one AC-charging port, one 12-volt DC cigarette lighter socket (5-8 amps), two 12-volt DC 5.5 x 2.1 mm power plug ports (3 amps each), one 5.5 x 2.1 mm solar power input port that will accomodate an extra solar panel that produces up to 5 amps, a pair of standard Type A USB ports, and ON-OFF switches for AC and DC power outputs.  The maximum combined/simultaneous output from the cigarette lighter socket and the two 12-volt DC power plug ports is 13 amps.  The control panel has a waterproof safety cover that opens and closes via a pair of turn knobs.  Case: water-resistant (IP65) and dust-proof hard case in dark grey that has a heavy-duty carrying handle, and that measures 17.4 x 13.6 x 5.7 inches in external dimensions.  LED: one 3-watt LED light that is located on one side of the hard case, that is controlled by an ON-OFF button that is located on top of the hard case, and that can be set to flash an SOS signal, remain illuminated, or be off.  LCD display: "intelligent" display system that indicates battery charge capacity indicator, charging status, errors, and AC and DC power output status.  USB: one pair of standard Type A USB charge ports, the combined output current of which is 2 amps.

     The hard case measures 17 1/2 x 13 3/4 x 5 1/2 inches, and the system weighs 22.6 pounds.  

        An additional solar panel (not included) may be added to the system to increase the power of the solar array.  The extra solar panel plugs into the control panel via a 5.5 x 2.1 mm barrel plug.  Please call us at 770 639 2244 for additional information.

     In the two photos below, one can see the Powerenz LiPo-48 - 50W system water-resistant and dustproof hard case, and the AC-powered 6-amp battery charger that is actually built into the hard case now.

In the photo below, one can see the top of the hard case, the carrying handle, the two rotating clasps that open and close the lid of the hard case, the waterproof digital LED display in the center, and the waterproof button to the left that controls the 3-watt LED light.

In the photo below, one can see the waterproof 3-watt LED light that is implanted in the sidewall of the hard case.

In the photo below, one can see the waterproof main ON-OFF switch that controls power in the hard case, and the waterproof cover of the control panel that is closed.  The cover of the control panel has two twist dials that allow the cover to be opened and closed.

In the three photos below, one can see that the cover of the control panel is opened, exposing the various power-in and power-out ports.  The various interfaces include one universal 120-volt AC outlet, one 12-volt DC cigarette lighter socket, two standard USB charge ports, one plug-in for the AC-powered battery charger, ON-OFF buttons for AC and DC power out, one plug-in for an extra solar panel, and two barrel plug-ins for 12-volt DC out.

In the photo below, one can see that the lid of the hard case is opened, exposing the 50-watt solar array that is folded.

 

 

In the photo below, one can see that the solar array is unfolded.

In the photo below, one can see that the lid of the hard case is opened, that the solar array is folded.

 

Customers who bought this also bought…